Cross Right Corner Decline and Incline (30-45 degrees) for 48mm Galv Pipe img2 although items can be supplied

although items can be supplied separately as 167M and 2 x 173F

The SSW056XMB (M6 Terminal Right Hand Thread) and SSW070XMB (M6 Terminal Left Hand Thread) require the use of the IF120X (Hydraulic Swager) to fasten the fitting to the wire

The castor with large screw (obviously)

often used where top rail meets corner upright on level sites

316 Stainless Steel in a Mirror Finish

Cross Right Corner Decline and Incline (30-45 degrees) for 48mm Galv Pipe img2 although items can be suppliedWhere would you normally use this galvanised pipe fitting ? The 286 is a 90 degree corner joint, often used on middle rail on angled sites and often paired with type 128. This fitting cannot be used where through tube (vertical in photo) has to be joined within the fitting. What size pipe does it fit to ? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 48mm. What is it made out of ? All of the pipe fittings